Ultimaker 2+ and 2+ Extended Maintenance Kit

        UltiMaker 2+ and 2+ Extended Maintenance Kit

        The UltiMaker 2+ Maintenance Kit contains the most commonly used replacement parts for the UltiMaker 2+ or UltiMaker 2 Extended+. It can be purchased in addition to your UltiMaker and used as an overall maintenance kit, or it can be used for spare parts.

        • $236.25
        Quantity:  
        OR

        What’s included?

        Below you can find an overview of all the parts that are included in the maintenance kit.

        1. 1x Glass plate
        2. 1x Bowden tube
        3. 1x PT100 B sensor
        4. 1x Heater cartridge
        5. 1x Grease
        6. 1x Machine oil
        7. 1x Calibration card
        8. 2x Build plate clamp
        9. 2x Clamp clip
        10. 2x Tube coupling collet
        11. 1x Hot end isolator
        12. 4x Olsson nozzles (0.40, 0.25, 0.60 and 0.80 mm)
        13. 2x TFM isolator coupler
        14. 1x Print head alignment aid
        15. 1x Hot end cooling fan
        16. 2x Print cooling fan 

        These items can be used for regular and corrective maintenance, or to perform the most likely repairs on your UltiMaker 2+. All the instructions for the repair procedures can be found on this page.

        Maintenance schedule

        To keep your UltiMaker 2+ in optimal condition we recommend the following maintenance schedule, based on 1,500 printing hours per year. 

        Every month  Every 3 months  Every year  
        Clean printer  Check for play on axles  Clean feeder and replace Bowden tube
        Lubricate axles  Check tension of short belts 
         Lubricate lead screw Z motor 
         Re-tighten hot end isolator 
          • SKU
            9518
          • Weight
            1.6535 lbs
        • Brand
          UltiMaker

        Related products