UltiMaker 2+ and 2+ Extended Maintenance Kit
The UltiMaker 2+ Maintenance Kit contains the most commonly used replacement parts for the UltiMaker 2+ or UltiMaker 2 Extended+. It can be purchased in addition to your UltiMaker and used as an overall maintenance kit, or it can be used for spare parts.
What’s included?
Below you can find an overview of all the parts that are included in the maintenance kit.
- 1x Glass plate
- 1x Bowden tube
- 1x PT100 B sensor
- 1x Heater cartridge
- 1x Grease
- 1x Machine oil
- 1x Calibration card
- 2x Build plate clamp
- 2x Clamp clip
- 2x Tube coupling collet
- 1x Hot end isolator
- 4x Olsson nozzles (0.40, 0.25, 0.60 and 0.80 mm)
- 2x TFM isolator coupler
- 1x Print head alignment aid
- 1x Hot end cooling fan
- 2x Print cooling fan
These items can be used for regular and corrective maintenance, or to perform the most likely repairs on your UltiMaker 2+. All the instructions for the repair procedures can be found on this page.
Maintenance schedule
To keep your UltiMaker 2+ in optimal condition we recommend the following maintenance schedule, based on 1,500 printing hours per year.
Every month | Every 3 months | Every year |
Clean printer | Check for play on axles | Clean feeder and replace Bowden tube |
Lubricate axles | Check tension of short belts | |
Lubricate lead screw Z motor | ||
Re-tighten hot end isolator |