Search

Fusion3 EDGE - Unrivaled 3D Print Quality At High Speed, Ease of Use, and Reliability

Fusion3’s ‘F-Series’ motion control system delivers faster speeds and greater visual quality and tight tolerances.

Upgraded Motion Control System

Including high-performance linear rails, Gates 2GT2 belts and specially tuned stepper motors

ANVIL Print Head

Patent-Pending print head system uses a surgical steel print tube, instead of a traditional nozzle. Provides faster printing, wear resistant and easier to maintain.

Upgraded Motion Control System

Including high-performance linear rails, Gates 2GT2 belts and specially tuned stepper motors

Bullet-Proof Bed Leveling

EDGE’s print surface is glass over a 1/4” milled aluminum tool-plate which provides a flat reference for our proprietary, lightweight probe, mesh bed leveling system. EDGE provides a near perfect first layer for every print.

F410 Replacement Filter Set 

Replacement filters for the F410 (requires filter assembly). Contains:

• 6 Carbon Filters which capture smell
• 6 HEPA Filters (Merv 11) which capture some % of emissions

Actual duration / life of the filters is unknown. It is likely that the HEPA filter will become clogged with dust before its ability to capture particulates is compromised.

F410 HEPA / Carbon Air Filter Assembly

Filter housing that bolts on to the exhaust port of the printer. Comes with 1 set of filters to provide filtration of the exhaust for your F410 3D printer. The carbon filter will remove some amount of smell from the exhaust of the printer. The Merv 11 HEPA filter will capture some amount of emissions from the plastics used when printing.

F410 Print Head with Hardened Steel 0.4MM nozzle.

Replacement F410 .4MM Print Head. Comes fully assembled and tested. 

Print Head: E3D Volcano

Layer Height (Min - Max): 20 - 300 microns

Min Feature Size: .5 mm²

Feature Tolerance: +/- .003” per inch

Print Nozzle: .4 mm hardened steel

Maximum Melt Temperature: 300C°

F410 Print Head with Hardened Steel 0.6MM nozzle.

Replacement F410 .6MM Print Head. Comes fully assembled and tested. 

Print Head: E3D Volcano

Layer Height (Min - Max):  100 - 400 microns 

Min Feature Size:  .75 mm²

Feature Tolerance: +/- .0045” per inch

Print Nozzle: .6 mm hardened steel

Maximum Melt Temperature: 300C°

F410 Print Head with Hardened Steel 0.8MM nozzle.

Replacement F410 .8MM Print Head. Comes fully assembled and tested. 

Print Head: E3D Volcano

Layer Height (Min - Max):  200 - 500 microns 

Min Feature Size:  1.0 mm²

Feature Tolerance: +/- .006” per inch

Print Nozzle: .8 mm hardened steel

Maximum Melt Temperature: 300C°